Installation tips for AWM-BT

Attach your clamp to the post and secure it to the desk as per the instruction manual. Clamp, grommet, and bolt through fixings each have an installation guide.

Glide the bracket onto the post, with the inside guide slotting neatly into the rear channel of the post. If the bracket guide is correctly inserted to the rear post channel, it feels secure and not loose around the post.

Measure your monitor height and position the bracket at a comfortable position on the post to provide your monitor clearance above the desk.

Some ultrawide monitors require a VESA adaptor, which is typically included with the monitor. Consult your monitor’s instruction manual for details.

Your Atdec bracket comes with spacers and longer screws for monitors with recessed VESA surfaces, and shorter screws for those with flat or protruding VESA surfaces.

It is recommended that you get assistance from another person to lift your monitor and slide the VESA adaptor into the saddle. After hanging your monitor, push the two side tabs in.

Movement of the display is expected if a load is applied to the corner. You should avoid putting a load on the corners of your display/s.

The tilt knobs on the left side of the bracket (when looked at from rear) are used to loosen the tilt mechanism. If the tilt knobs do not loosen sufficiently for your monitor to tilt, the tension is set too high. Use the provided hex key to loosen tensions screws shown in this image. Loosen top and bottom screws a quarter turn at a time, clockwise, until you achieve the desired tension. Then position your monitor and tighten only the tilt knobs.

The reverse can be done if your tilt mechanism needs more tension.

If mounting a second display, ensure the top bracket is positioned with enough space for the top monitor to clear the lower monitor. We recommend you plan for 12mm or ½” gap and use after-installation microadjustments to eliminate the gap. 

Use the fine tune adjustment knobs to ensure your monitor is level and to close the gap with two-monitor setups.

• If you have vertically stacked monitors
• Top and bottom monitors can be different size & model
• Adjust tilt to compensate for varied monitor depths

• Get help to attach and remove monitor/s
• Don’t risk your expensive ultrawide display! 

• Remove monitor before loosening bracket with hand knob
• (Fine-tune adjustment knobs and tilt knobs are designed to use with display attached to bracket/mount)